![]() ![]() DEBUG2 and DEBUG3 each specify higher levels of verbose output. The possible values are: QUIET, FATAL, ERROR, INFO, VERBOSE, DEBUG, DEBUG1, DEBUG2, and DEBUG3. Gives the verbosity level that is used when logging messages from ssh(1). The file name may use the tilde syntax to refer to a user's home directory or one of the following escape characters: ‘%d’ (local user's home directory), ‘%u’ (local user name), ‘%l’ (local host name), ‘%h’ (remote host name) or ‘%r’ (remote user name). ssh(1) will try to load certificate information from the filename obtained by appending -cert.pub to the path of a specified IdentityFile. Additionally, any identities represented by the authentication agent will be used for authentication. The default is ~/.ssh/identity for protocol version 1, and ~/.ssh/id_rsa and ~/.ssh/id_dsa for protocol version 2. Specifies a file from which the user's RSA or DSA authentication identity is read. Note that this option applies to protocol version 1 only. The meaning of the values is the same as in gzip(1). ![]() ![]() The default level is 6, which is good for most applications. The argument must be an integer from 1 (fast) to 9 (slow, best). Specifies the compression level to use if compression is enabled. If the option is set to “no”, the check will not be executed. This allows ssh to detect if a host key changed due to DNS spoofing. If this flag is set to “yes”, ssh(1) will additionally check the host IP address in the known_hosts file. Note that this seems to be REQUIRED although being optional in older releases.ĭelay after a connection failure before trying to reconnect. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |